I ran out of Raka epoxy, so I ordered a 1/2 gallon kit, that should be enough to finish the roof with 3 or four coats. I also ordered some braodhead rivets so I can attach my trim to my hatch .I mounted my hurricane hinge and attached my hatch supports.  I tried using gas piston type supports but could not get the to work correctly, the old finished mechanical supports will work just fine. Now I can work on my galley lights and cabinets.

     The roof now has to layers of 1/8 inch Luan in place, sealed between the cabin ceiling and the roof is 1 1/2 inch of insulation, this was glued in place with Loctite PL Premium construction adhesive, then each layer of Luan was glued in place with the same adhesive.  I sealed the screw holes from the firring strips  I used to hold the Luan in place until the adhesive cured. Next will be 3 coats of Raka epoxy and 3 coats of marine topside paint will be applied, same process that I used on the hatch and walls.